ProTool HydroCart Filter Kit Pro

Quick Overview

Manufactured from 100% pure polypropylene fibers
Open your DI filter housing, remove the exhausted DI filter and replace it with the new one
he active filter media material is mineral based with a polypropylene cover that insures no carbon fines are released into the stream while offering strong absorptivity.
High efficiency, low pressure drop, and long life

Item #: 150-0050 UPC : 00669893015937 MPN : 20025-3

$111.10

$127.50

In Stock

HydroCart Filter Kit Pro

Sediment Filter 2.5 inch x 10 inch

Filter fits the 2.5" x 10" filter housings as well as being the replacement sediment filter.

5 micron nominal filtration
FDA listed materials
Manufactured from 100% pure polypropylene fibers
High dirt holding capacity
High efficiency, low pressure drop, and long life

Polypropylene Replacement Filter Cartridge for removal of Sand, Silt, Dirt, Rust and sediments from the water source.For filtering water only.This filter cartridge fits most standard in-line Filter Housings 2.5x10Maximum water temp 125 degrees.5 Micron Rating is nominal, Installation and housing can impact performance.Caution: For Drinking Water or commercial use applications, do not use where the water is microbiology unsafe or is of unknown quality without adequate disinfection before or after the filter.Does not filter for chemicals, chlorine, cysts, bacteria or viruses.Removes large and fine particles, the main function of this sediment filter is to remove particles from a water, such as sand, dirt, silt, and rust.Sediment filter is made of fine melted polypropylene, which is blown and spun in a cylinder-like form.

2.5 x 10, 2.5in x 10in, 2.5 inch x 10 inch, 2x10

DI Resin 4.5 x 10" Replacement Filterm - includes the DI Resin

Sealed in a plastic bag for maximum freshness.

Open your DI filter housing, remove the exhausted DI filter and replace it with the new one

Carbon Filter and 5 Micron Sediment Filter Cartridges insert for 2.5in x 10in housing, Fits any standard 2.5 x 10 housing.

The carbon block filter consists of high-quality activated carbon. It is effective in reducing free chlorine, bad taste, odor, THM, organics, hazardous chemicals and more.

Depending on source water quality or flow rate, it needs to be replaced every 2 months or about 1000 to 1,200 gallons of water. Each filter is individually sealed to keep freshness. Fits models using standard 10 in. x 2.5 in. whole-house water filters.

Often used before an RO Membrane to protect the membrane from Chlorine in the water. Chlorine in the water greatly reduces the RO Membrane service life.

Knocks out cloudiness, bad tastes and odors while removing removes 99% nominally of the chlorine in the water. This filter is also effective on organic compounds like herbicides and industrial solvents and other contaminants like trihalomethanes.

The filter offers a steady flow and high absorption.

Fits standard 10 in. x 2.5 in. housings offering quality commercial, industrial and whole house water filtration systems.

Individually sealed for freshness.

Offers improved taste and a reduction in odor.

Activated Carbon Filter Cartridge is extruded and shaped by activated carbon fines. The active filter media material is mineral based with a polypropylene cover that insures no carbon fines are released into the stream while offering strong absorptivity.