ProTool Foaming Hose End Sprayer

$11.20

Description

Foaming Hose End Sprayer

The Foaming Sprayer offers excelent cleaning capability for a variety of small areas.

Just fill up the chemical bottle the Mix Instructionas and the Hose End Foaming Sprayer can tackle :

Soaping up 3 Cars
Spraying a Deck
Spraying down 30 to 40 feet of wood or vinyl fencing
Spraying the Front Porch for Mold and Mildew
Spraying the siding to remove mold on one wall of a typical house

The Hose End Foaming Sprayer offers an easy way to spray a Precision Mixed Cleaning solution onto Exterior Building Surfaces.

This mix ratio guidance is our recommended starting point for the differnt surfaces you can clean

Specifications
Model Number	Foamer 1:12
Ratio	12(water):1(Bottle Contents)
Foaming distance (under 60psi)	6 to 10 feet
Total Flow from 2L Bottle (mix)	Greater than 6 Gallons of Mix
Bottle	2L PET Clear Bottle 515-0020 (28/410 thread neck) (Not Included)
Hose fitting nut thread	3/4” Garden Hose

Great for Cleaning Cars, Trucks and RVs

Spraying 6oz of Shine Up with 60oz of Water in 2L Bottle

Able to Soap up 3 Cars with the 2 Liter Bottle attached restulting in > 6 gallons of Mix

Shine Up and the Foaming Sprayer offer great detergent spreading on your vehicle surface

Foaming gets the soap on the vehicle quickly and evenly

Capable of Foaming 3 Car Washes using only on 6 to 8 Ounces of Shine Up mixed with Water in the 2L bottle. This allows you to clean 30 or more vehicles from a single bottle of Shine Up

hose-end-foaming-sprayer-protool-28-410-neck-515-0020.jpg

(Bottle not Included)

Clean and Sanitize Exterior Surfaces

Use the Hose End Foaming Sprayer with Sticky and 10% to 12.5% Bleach (SH - Sodium Hypochlorite) to clean and sanitize small areas

stucco, bricks, vinyl, Aluminum siding, decks, wood and vinyl fenses, outside bathrooms, playground equipment, front porches, eaves.

Learning Center Soft Wash Cleaning section

The Bleach Mix will clean and sanitize while removing the mold and mildew from the surface leaving a clean fresh finish.

Be sure to rinse the area well with water after cleaning and to protect any vegetation in the area.

Learn About Protecting Plants

Dosing Syringe

Draw the Sticky and Delver into the 2L Chem Bottle

Sticky Super Concentrate

ProTool Sticky is used with sodium hypochlorite (SH) and water to allow a better spreading of the solution and a longer dwell time when cleaning mold, dirt, and mildew stains

Sodium Hypochlorite (SH) or Pool Bleach

The SH provies the cleaning power to remove the mold and mildew, purchased locally in bulk or in gallons as Pool Bleach or Chlorinating Liquid

Softwash Instructions

Equipment:

Hose End Sprayer

https://www.jracenstein.com/p/protool-foaming-hose-end-sprayer/515-0020

Get a couple of clear bottles so you can fill one while the other is spraying

https://www.jracenstein.com/p/protool-bottle-2-liter-clear-28-410-neck/515-0021

A bottle of Sticky

https://www.jracenstein.com/p/protool-sticky/83-07m/83-058/

Used for Dosing

https://www.jracenstein.com/p/protool-dosing-syringe-10ml-033-ounces/515-0022

Then some areas (typically less than 10% for mold only) will require agitation

https://www.jracenstein.com/p/brush-bi-level-10in-green-very-soft/66-509

You may have a need to agitate your cleaned area for other surface debris like bird droppings

Bleach

Go get at least 10% Pool Bleach available locally at Lowes, Leslies pool supply, etc

Notes:

Your clothing will spot from the beach so wear stuff that you don't care about.
Don't spray the solution so heavy that is will runoff onto other surfaces or unwanted areas,
Spray just enough to gain coverage and soak but not run off into unintended areas
Spraying twice in a contained manner is better that a bunch of unused chemical running off.
Bleach will discolor and/or kill grass, plants, etc so no overspray or allow runoff on to vegetation

Mixing

use the Dosing Syringe or Pour an ounce of sticky in the clear bottle, then fill the pottle with the pool bleach

The Sprayer has three settings, Clean, Off and Rinse
The Clean setting has foaming action to promote coverage the Sticky surfactant helps with that too.
Spray the affected area
For large areas and stairs, siding etc.
We recommend working your way uphill with the spray.
start from the bottom up so that you can manage the run-off the best.

The point of the sprayer is to mix on demand and then spread the mixture out with the foaming action

so it is easier to avoid runoff and use less solution

There are two videos of the sprayer in action though it is Shine Up spraying cars it is representative of the spraying action...

Coverage will be at least a 1 car garage/ 1 car parking space per bottle,

often more depending on the amount of the mold, per bottle.

Let the solution dwell for a bit, reapply as needed, let the chems do the work..

Rinse with garden hose, copious amounts of water, don't let the bleach mix dry on surface

Note:

Spray adjacent greenery with water before this task

and again after this task (twice) after to wash any possible overspray way.

Do this in 49 degree or warmer weather, and less than 90 degrees.

As a casual user I would not apply above when it is perhaps 80 degrees out